Publicité
No-Mar Pad
Replacing the No-Mar Pad
(Fig. 5)
The nailer is equipped with a pre installed
No-Mar Pad 1 which may be replaced once
worn.
To replace the No-Mar Pad 1:
1. Remove the Battery Pack 9.
2. Position nailer onto a flat stable surface
and pointed away from yourself and
bystanders.
3. Pull the No-Mar Pad 1 off, following
the bend on the end of the Workpiece
Contact 2.
4. Install the new No-Mar Pad 1 onto the
end of the Workpiece Contact 2.
Fig. 5
2
1
14
Assembly
No-Mar Pad Storage
(Fig. 6)
A spare No-Mar Pad 1 can be stored on the
tool for easy accessibly. Insert the No-Mar
Pad 1 onto the No-Mar Pad Storage 12 loca-
tion, found on the inner side of the Maga-
zine 14.
Fig. 6
12
Publicité
