Publicité
JMA
NOMAD BIT GO
the machine.
5) Install the new electronic card by securing it with the four
screws (T2).
6) Connect the four wires to the electronic card and, finally,
connect the yellow power connector to the battery.
7) Replace the lower housing plate.
See Figure 15
6.7 REPLACING THE JACK CONNECTOR
1.
Switch off the power switch (11), switch
off the master switch (15), close the
protective screen (16) and check that
the machine is NOT connected to the
battery charger.
1) Access the lower housing as explained in Section 6.4 of this
manual.
2) Disconnect the yellow power connector from the battery.
3) Disconnect the red battery charging connector from the
battery (the one connecting the two wires from the jack to
the battery).
4) Using a spanner, release the nut (T3) securing the jack
connector to the machine.
5) Remove the jack connector (14) and its wiring through the
hole in the machine.
6) Install the new jack connector following the same steps
but in reverse order.
See Figure 16
6.8 REPLACING THE MASTER SWITCH
1.
Switch off the power switch (11), switch
off the master switch (15), close the
protective screen (16) and check that
the machine is NOT connected to the
battery charger.
1) Access the lower housing as explained in Section 6.4 of this
manual.
2) Disconnect the yellow power connector from the battery.
3) Disconnect the round connector from the master switch.
4) Using a spanner, release the nut (T4) securing the master
switch to the machine.
5) Remove the master switch (15) and the protective screen
KEY CUTTING MACHINE
(16).
6) Install the new master switch following the same steps but
in reverse order.
See Figure 17
6.9 POWER SWITCH REPLACEMENT
See Figure 18
Follow the steps below to do this:
1) Access the interior of the machine as indicated in Section
6.4 of this manual.
2) Squeeze the tabs on the switch to remove it.
3) Disconnect the wires from the switch, noting down the
position of each one beforehand.
4) Connect the wires to the new switch.
5) Squeezing the tabs on the switch, push it all the way back
into position
6.10 REPLACING AND TIGHTENING THE BELT
See Figures 19A and 19B
Follow the steps below to do this:
1) Release the three screws securing the cutter and brush
protector and then remove it.
2) Release the tensioning screw (T7) using the 3 mm Allen
key.
Switch off the power switch (11), switch off the
master switch (15), close the protective screen (16)
and check that the machine is NOT connected to
the battery charger.
Publicité
