Publicité
Installing the Base Station
1. Place the base station against a wall, and connect the power cord to it. Store
the power cord in the back of the base station.
Note:
Do not place the vacuum and the base station near heat sources or in humid
areas, such as by a radiator, in a kitchen, or in a bathroom.
2. Press and hold the release button on the water tank cover and simultaneously
rotate the cover to open it. Then add clean tap water to the water tank up
to the maximum water level mark and install the cover back. It is secured in
place when you hear a click.
Note:
Do not add any liquid other than tap water to avoid potential danger.
Click into Place
7
MAX
Publicité
