Publicité
Charging
Battery Level Display
1. Place the vacuum on the base station, and the vacuum will begin charging.
The display will go out 20 seconds after the vacuum is fully charged.
2. The number on the display represents the current battery level in a
percentage during charging. The display will go out 20 seconds after charging
is completed.
3. The vacuum cannot be charged when it is in the process of water adding, self-
cleaning, or drying.
charging
How to Use
Display and Buttons Instructions
Auto Mode
Water Absorbing
Mode
Turbo Mode
Self-cleaning Button
• Press to start self-cleaning and drying.
Hot Water Adding Button
• Press to start adding hot water.
When adding hot water, the base station will first pump the
low-temperature water out of the vacuum, and then start
to add high-temperature water to it.
Mode Switch Button
• Cycle through the modes when the vacuum is on.
Power Button
• Press and hold to turn on/off the vacuum.
9
Water Adding Indicator
(Blue for room
temperature, and red for
high temperature)
Self-cleaning Mode
Temperature Indicator
High-temp Mode
Error Status
Publicité
