Publicité
Cleaning the Floor
1. Remove the vacuum from the base station, step on the floor brush with one
foot and pull back the handle to tilt the vacuum. Press and hold the button
to turn on the vacuum.
2. Press the button
to cycle through the modes of auto, water absorbing, and
turbo.
3. After using the vacuum, press and hold the button
To avoid residual dirty water, the vacuum will continue to run for a few
seconds before turning off.
4. Put the vacuum back onto the base station properly after using it. Do not
place the vacuum against a wall to prevent it from tipping over due to
improper placement.
Auto Mode
Water Absorbing Mode
Daily stains
Water stains cleaning
cleaning
to turn off the vacuum.
Turbo Mode
Stubborn stains cleaning
(Combined with high-temp
mode for better results)
11
Self-cleaning
1. Place the vacuum properly on the base station and press the button
to start self-cleaning. During drying, the roller brushbar will consume the
vacuum's power to rotate and the vacuum cannot be charged. After the
drying is completed, the vacuum will automatically start charging.
2. To stop self-cleaning or drying, press the button
Note:
Clean the dirty water tank in time after self-cleaning to prevent odors.
or
.
Publicité
