Publicité
• Product identification
1. Determining the number of paired devices
You can identify the number of paired products and identify each product one by
one at any time.
In the Freeze Protection mode, press the
The display will show the number of the
paired device.
2. Single device identification
To determine the device number, switch
on the device in Standby mode.
Once the device is in Standby mode,
press the button to refresh the remote
controller display.
The corresponding device number is
displayed.
This identification number is used to set
up each device correctly.
• Cancelling radio pairing
You can cancel the radio connection between the device and the remote controller
at any time.
Note: If the remote controller controls, for example, a radiator, you can cancel the
radio connection either from the remote controller or directly at the receiver located on
the heater. In this case, follow its installation and operation manual.
and
13
buttons for 5 seconds.
EN
Publicité
