Publicité
3. The remote controller (room temperature
controller) is in pairing mode. The
identification key of the device you want to
pair (e.g. Device 1) is also displayed. You
can assign up to 5 devices to one remote
EN
controller. If you want to add more devices
so that they are all controlled by the
remote controller, the number will increase
with each pairing of a new device. Then
proceed to pair the device controller (see
the installation and operation manual).
If you have already paired 5 devices, you
will see the message
control other devices, you must unpair
one device or pair it to another remote
controller.
4. Enter the power of the controlled device
as indicated on its nameplate. Press
or
device from 300 to 2000 W in 50 W steps.
ATTENTION, incorrect power settings
would cause control anomalies.
Save by pressing the
to set the power of the
button.
. To
10
Publicité
