Maintenance; Accessories - Truma DuoControl CS Mode D'emploi Et Instructions De Montage

– Carry out the check for leaks (e.g in Germany in accordance
with G 607).
– If the gas system is leaking, close the gas cylinder valve and
have the gas system repaired immediately by an expert. Do
not open the gas cylinder valve until the repair is complete.
– After the check is complete, be sure to turn the test valve
back (90 degrees anticlockwise until it will turn no further)
and replace the protection cap.
– Screw the threaded cap back onto the test connection.

Maintenance

The DuoControl CS gas pressure regulation system is main‑
tenance free.
In Germany, the gas system must be retested every 2 years by
a liquid gas specialist (DVFG, TÜV, DEKRA). The test must be
confirmed on the respective test certificate (G 607).
In countries where testing is not mandatory, we recommend
that the gas system is tested every 2 years for your own
safety.
Pressure regulation devices and hoses must be replaced with
new ones no more than 10 years after their date of manufac‑
ture e (every 8 years if used commercially). The operator is
responsible for this.

Accessories

High-pressure hoses
see Page 74
1.5-metre connection hose
for the connection of external gas cylinders
– connection G.5 for Germany –
(part no. 50020‑61300)
Replacement seal
for high‑pressure connection, M20 x 1.5 (G. 13);
(part no. 50020‑76300)
Remote indicator (including EisEx)
shows the removal status from inside the vehicle.
(part no. 50211‑01)
EisEx regulator heating
(part no. 53101‑01)
Elbow union 90 °
(part no. 50020‑56000)
Additional kit
required when gas cylinders are more than 100 cm apart
(part no. 50020‑61100)
Gas remote switch
for shutting off the gas supply from the vehicle interior
GS 8 (part no. 57014‑01)
GS 10 (part no. 57024‑01)
Gas filter
suitable for all wall‑mounted gas pressure regulation systems
with a M 20 x 1.5 inlet screw joint (male thread – G.13). Instal‑
lation upstream of the gas pressure regulation system.
(part no. 50600‑01)
17