Operating Instructions; Control And Display Panels; Start-Up; Changeover - Truma DuoControl CS Mode D'emploi Et Instructions De Montage

Masquer les pouces Voir aussi pour DuoControl CS:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22

Operating instructions

Control and display panels

b
d
Figure 1
a = control knob for the operating/reserve cylinder
b = status display – operating/reserve cylinder (green/red)
c = green reset button – crash sensor triggering element
d = green button – hose rupture protection
Truma offers a remote indicator as an accessory (part no.
50211‑01) to permit reading of the operating cylinder's
status from inside the vehicle.

Start-up

– Open the gas remote switch if present.
– For example, turn control knob (a) to the left until it stops
(left connection is operating cylinder.
14
d
a
c
– Connect gas cylinders and make sure all hose connections
are in good condition.
– Open the valves on both gas cylinders.
– Firmly press the hose rupture protection (d – green button)
on the high‑pressure hose for about 5 seconds. The display
in the mica window (b) turns green.
– If necessary (e.g. after a new installation or inadvertently
striking the gas cylinder against the gas pressure regu‑
lation system), press the green reset button (c – crash
sensor triggering element reset) on the DuoControl CS for
about 5 seconds.

Changeover

As soon as the pressure in the operating cylinder falls below
0.5 bar, the DuoControl CS automatically switches over and
begins taking gas from the second gas cylinder. The display
in the mica window turns red.
In extreme cold or when a large amount of gas is con‑
sumed from the cylinder over a long period of time, the
gas pressure may fall below 0.5 bar even though there is still
some gas left in the cylinder. This may result in gas being
taken from both gas cylinders simultaneously.
If necessary, use the control knob (a) to manually select which
cylinder will be operating and which will be held in reserve.
Always turn control knob (a) as far to the left or right as it will
go (an intermediate position will cause gas to be removed
from both gas cylinders simultaneously).

Publicité

Table des Matières
loading

Table des Matières