Publicité
OPERATING INSTRUCTIONS
IMPORTANT: PRIME THE UNIT BEFORE FIRST USE
To prime the unit, follow these steps:
1.
Fill the water reservoir to between the MIN and MAX markings on the tank.
2.
Remove the milk reservoir. (Tilt it up first, then pull out.) Fill the milk reservoir with water
(not milk) to between the MIN and MAX markings on the tank and return it to the unit.
(To insert it, tilt down and push it firmly into place.)
3.
Place a large heatproof cup or mug on the metal coaster set over the drip tray. (NOTE: The
coaster is reversible to make the height adjustable.)
4.
Set the froth strength to Extra. Use the silver froth dispensing tube lever to position the
froth dispensing tube inside the cup.
5.
Place an empty portafilter basket in the portafilter.
6.
Fit the portafilter onto the brew head unit, being sure it's locked in place. (See p. 15 for
more information on placing the portafilter.)
7.
Plug in the unit and turn it on. (The power switch is located on the side toward
the bottom.)
8.
Press the Double Cappuccino button.
9.
The button will blink as the unit preheats; do not press the button again or you will cancel
the function.
10.
Let the cup fill with water from the brew head and from the froth dispensing tube. When
the brew cycle function ends, the unit will beep three times. Carefully dispose of the water
in the cup and in the milk reservoir. The unit is now primed and ready for use.
11
Publicité
