Publicité
PX MultiSensor Charger
Charging PX Sensors
About the battery and its charger
Every PX family sensor is equipped with a custom
made Li-Ion battery. The PX MultiSensor Charger is
especially designed for charging this battery. The PX
MultiSensor Charger must be used to charge all PX
family sensors.
WARNING
Do not use the PX MultiSensor Charger on the
bridge or where it is powered from the same power
circuit as the bridge equipment.
Cleaning the sensor charger sockets
In order to ensure that the charging is efficient – and to
reduce the wear and tear of the sockets and the charger
plug – it is important that the sockets are cleaned
thoroughly before charging or sensor configuration
takes place.
Procedure
1
Use high pressure air and direct the nozzle into
each of the sockets. Blow out water and moisture.
2
Use a small brush or a cotton swab and clean each
socket thoroughly.
3
Wipe off the sensor with a dry lint free cloth. Pay
special attention to the area close to the sensor
sockets.
Charging the sensor battery
Important
Never charge a sensor when it is mounted in the door
adapter or on the trawl.
You must charge your sensor every three months if it
is not in use.
375327 / F / 2023–10–13
Publicité
