Wolf ICBSRT304 Instructions D'installation page 6

W O L F
I N S TA L L AT I O N
IMPORTANT NOTE: This installation must
be completed by a qualified installer,
service agency or gas supplier.
IMPORTANT NOTE: Save these Installation
Instructions for the local inspector's use.
R AT I N G P L AT E
I N F O R M AT I O N Please read the entire Installation Instruc-
tions prior to installation.
Installer: please retain these instructions
Model Number
for local inspector's reference, then leave
them with the homeowner.
Homeowner: please read and keep these
Serial Number
instructions for future reference and be sure
to read the entire Use & Care Information
prior to use.
IMPORTANT NOTE: This appliance must be
installed in accordance with local codes. The
correct voltage, frequency and amperage must
be supplied to the appliance from a dedicated,
grounded circuit which is protected by a
properly sized circuit breaker or time delay
fuse. The proper voltage, frequency, and
amperage ratings are listed on the product
rating plate.
Record the model and serial numbers before
installing the sealed rangetop. Both numbers
are listed on the rating plate, located on the
underside of the sealed rangetop. Refer to the
illustration below.
6
S E A L E D B U R N E R R A N G E TO P
R E Q U I R E M E N T S
B E F O R E
Y O U S TA R T
Proper installation is your responsibility.
Have a qualified technician install this
sealed rangetop. You must also assure that
electrical installation is adequate and in
compliance with all local codes and ordi-
nances.
Prior to installation, ensure that the local
distribution conditions (nature of the gas
and gas pressure) and the adjustment of
the appliance are compatible.
Proper gas supply connection must be
available; refer to Gas Supply Requirements
on page 12. Electrical ground is required;
see Electrical Requirements on page 15.
The adjustment conditions for this appli-
ance are stated on the label (or rating
plate). The data plate can be found on the
underside of the sealed rangetop.
Location of rating plate
under control panel
Rating plate location