Wolf ICBSRT304 Instructions D'installation page 15

Masquer les pouces Voir aussi pour ICBSRT304:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

I N S TA L L AT I O N
I N S T R U C T I O N S
E L E C T R I C A L
R E Q U I R E M E N T S
ELECTRICAL SHOCK HAZARD —
Plug into a grounded 3-prong adapter.
Do not remove ground prong.
Do not use an adapter.
Failure to follow these instructions can
result in electric shock, fire or death.
IMPORTANT NOTE: If codes permit and a
separate ground wire is used, it is recom-
mended that a qualified electrician determine
that the ground path is adequate.
IMPORTANT NOTE: Check with a qualified
electrician if you are not sure whether the
sealed rangetop is properly grounded.
IMPORTANT NOTE: Do not ground to a gas
pipe.
A 220-240 V AC, 50/60 Hz, fused electrical
supply is required. A time-delay fuse or circuit
breaker is recommended. It is recommended
that a separate circuit serving only this appli-
ance be provided.
Electronic ignition systems operate within
wide voltage limits, but proper ground and
polarity are necessary. In addition to checking
that the outlet provides 220-240 V AC power
and is correctly grounded, the outlet must be
checked by a qualified electrician to see if it is
wired with correct polarity.
This appliance, when installed, must be electri-
cally grounded in accordance with local codes.
R E C O M M E N D E D G R O U N D M E T H O D
IMPORTANT NOTE: For your personal safety,
this sealed rangetop must be grounded. This
sealed rangetop is equipped with a 3-prong
ground plug. To minimize possible shock
hazard, the cord must be plugged into a
mating 3-prong ground-type outlet, grounded
in conformance with all local codes and ordi-
nances. If a mating outlet is not available, it is
the obligation of the customer to have a
properly grounded, 3-prong outlet installed by
a qualified electrician.
IMPORTANT NOTE: If product is connected to
a GFCI protected outlet, nuisance tripping of
power supply may occur, resulting in loss of
product operation.
W I R I N G D I A G R A M
The wiring diagram covering the electrical
circuit is located on the inside left wall of the
rangetop.
15

Publicité

Table des Matières
loading

Table des Matières