Publicité
only one sensor is connected).
3. Insert 2 batteries (AAA size 1.5V) into the battery compartment (27)
strictly according to the polarities shown.
4. Reinsert the battery compartment cover.
Low battery indication
When batteries need to be replaced the respective low battery indicator
for the main unit (8) or the outdoor sensor (12) will be shown on the
display of the main unit.
USING TABLE STAND OR WALL MOUNTING
The main unit can be placed on a flat surface (e.g. table) with the fold-
out stand (19).
The main unit and the outdoor sensor can be mounted on walls using
the recessed wall mount hanger (16, 24).
OPERATION
Receiving measurements
Once batteries are installed to the outdoor sensor, it will start
transmitting temperature readings at roughly 60 second intervals. As
soon as batteries are installed in the main unit it will start searching for
a signal from the outdoor sensor for about 3-4 minutes. Upon successful
reception of the signal, the outdoor temperature will be displayed on the
main unit. The main unit will automatically update its readings at about
60 second intervals.
NOTE!
When the outdoor temperature is above or below the measurement
range, the display will show HHH (high) or LLL (low).
Manual time setting and other settings
To make manual settings, proceed as follows:
1. In normal time mode press the
to enter the settings mode. The value to be set is flashing. Value
settings order: hours > minutes > 12/24 hours > On/Off
2. Press
or
3. Press
to switch to the next setting.
4. Press
or
5. Press
to switch to the next setting.
6. Press
or
7. Press
to switch to the next setting.
to set the hours for the current time.
to set minutes for the current time.
to select 12 or 24 hours time mode.
button (17) for approx. 3 seconds
GB
19
Publicité
