en-us Prepare installation space
Solid surface or laminate countertops often require
¡
special installations. For example, heat-reflective tape
and rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to your
countertop.
2.6 Gas requirements
Ensure that the requirements for the gas supply are met.
The cooktop is shipped from the factory for use with
natural gas. For use with LP conversion, a certified
technician or installer must do the conversion.
Supply pressure:
Natural Gas: 7 inches water column (17.4 Millibars)
¡
Propane Gas: 11 inches water column (27.4 Millibars)
¡
The propane gas tank must be equipped with its own
¡
high pressure regulator in addition to the pressure
regulator supplied with this unit.
2.7 Electrical requirements
Ensure that the following electrical requirements are met.
CAUTION
Do not use an extension cord with this appliance.
This appliance requires a 60 Hz, 15 Amp, 120 V AC
¡
connection.
The appliance is equipped with a 40" (1000 mm) power
¡
cord.
The power connection must remain accessible from the
¡
front of the cabinet after the installation is complete.
3 Prepare installation space
Prepare installation space
Create the cutout in the countertop according to the
Prepare installation space
instructions.
General countertop requirements:
The angle of the cut surface to the countertop surface
¡
must be 90°.
With multi-layered countertops, secure strips laterally in
¡
the cutout if necessary.
After creating the cutout, remove all debris.
¡
Follow the countertop manufacturer's recommendations
¡
for protecting the cut edges, e.g. apply heat resistant foil
tape.
8
3.1 Installation dimensions
*For installation in a kitchen island.
Installation above a drawer
A
min. ¾" (19 mm)
max. 2" (50 mm)
B
5⅞" (150 mm)
C
2¾" (70 mm)
D
3¼" (80 mm)