Publicité
en-us Installation procedure
4.7 Assembling the burner parts
The burner parts must be properly placed for the cooktop
to function properly.
Note
If the burner parts are not properly placed, one or more of
the following problems may occur:
The burner flames are too high.
¡
Flames shoot out of the burners.
¡
The burners do not ignite.
¡
The burner flames light unevenly.
¡
The burners emit gas odor.
¡
WARNING
Remove all tape from the burner parts and the cooktop
surface before using the appliance.
Assemble the burner parts according to the illustration.
1.
Make sure that the prongs of the burner cap fit snugly
‒
into the groove of the burner base.
1
2
3
4
Burner cap
1
Burner base
2
Thermocouple
3
Igniter
4
12
1
2
4
3
Check to make sure that there is no gap between the
2.
burner parts. You may gently try to move the burner
parts from side to side to check if they are properly
seated.
4.8 Installing the burner grates
WARNING
Improperly positioned grates can cause flare-ups.
Position all grates properly on the cooktop whenever
▶
the cooktop is in use to properly support pots and avoid
spills.
Make sure each of the four feet of the grates is placed
▶
into the corresponding dimples on the cooktop surface.
Do not use a grate if the rubber feet are missing or
▶
damaged.
4.9 Checking the installation
Check if your unit is working properly after you have
completed the installation steps.
WARNING
Before you turn on power supply, make sure all controls
are in the OFF position.
Ensure that the burner caps are properly positioned.
1.
Publicité
