Mounting The Luminaire - Waldmann LINURA.edge LEA Mode D'emploi

Luminaire pour machine
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENG
3.2

Mounting the luminaire

Mounting the fastening elements
NOTES:
The two outer fastening elements must
ƒ
be mounted to the mounting surface at a
distance of a minus 30 mm, see Tab. 2.
For the following luminaire versions,
ƒ
you also have to mount a third fasten-
ing element and an intermediate holder.
-
LEA 2700/850
-
LEA 900/ YEL
-
LEA 3000/850
-
LEA 1000/ YEL
The fastening element for the interme-
ƒ
diate holder must be mounted in the
middle section between the two outer
fastening elements.
The tolerance range of the holders and
ƒ
of the intermediate holder, relative to
the fastening elements, is in each case
±15 mm.
For mounting the fastening elements,
ƒ
flat-headed screws must be used that
are suitable for the respective mount-
ing surface. These screws may have a
maximum shaft diameter of 4 mm, a
maximum head diameter of 8 mm and
a maximum head height of 3.5 mm.
For mounting the fastening elements
ƒ
to metal sheets, suitable self-tapping
screws can be found in the scope of
delivery of the luminaire.
28
Fig. 1: Mounting the fastening elements
X Mount the fastening elements A to the
mounting surface in parallel to each
other using suitable screws, see Fig. 1.
Mounting the holder
Fig. 2: Mounting the holder
X Place the holder B on the side part
such that the detent lug is located in
the groove of the side part and the
holder locks into place in the side part,
see Fig. 2.
X Mount the second holder to the oppo-
site side part of the luminaire such that
the two holders are aligned in parallel
to the mounting surface.
If desired: Mounting the intermediate
holder
Fig. 3: Mounting the insert in the interme-
diate holder.
Mounting
A
B
C
D
E

Publicité

Table des Matières
loading

Table des Matières