Miele HS19 Mode D'emploi page 31

 After cleaning the fine dust filter and
pre-filter, reinsert the former into the
latter by pressing the round cap on
top of the fine dust filter down as far
as it will go.
To continue achieving the best
possible cleaning results, replace the
fine dust filter (HX FSF-2) with a new
one after approx. 3 years.
 Reinsert the pre-filter in the dust
container (Fig. 41).
 To do this, line up the guides (arrows)
and turn the pre-filter back to its
original position (Fig. 42).
 Close the dust container flap, making
sure it clicks into place.
 Replace the dust container on the
PowerUnit connector.
Cleaning the dust container
Clean the dust container as required.
 Remove the dust container.
 Empty the dust container over a bin
and lift the pre-filter upward to
remove it (Fig. 39).
 Clean the dust container using water
and mild detergent.
 Dry the dust container carefully.
 Reinsert the pre-filter in the dust
container and turn the pre-filter back
to its original position (Figs. 41 + 42).
 Replace the dust container on the
PowerUnit connector.
Cleaning the Electrobrush / handheld
brush (depending on model) (Fig. 43)
 Disconnect the
Electrobrush / handheld brush from
the vacuum cleaner (Fig. 10).
 Place the Electrobrush / handheld
brush upside down on a level, clean
surface.
 Use a pair of scissors to cut any
threads or hairs that have wound
themselves around the roller brush. To
guide the scissors, move along the
guide track on the roller brush.
Then run the vacuum cleaner to vacuum
up the cut threads and hairs.
If the small running wheels are very
heavily soiled or blocked, you can
remove them for easier cleaning (not
necessary in the case of the handheld
brush). To remove them, use a flat-
head screwdriver.
Removing the roller brush from the
Electrobrush (Fig. 44)
(Not possible with the handheld brush)
You can take the roller brush out of the
Electrobrush in order to remove
stubborn soiling and clean the inside of
the Electrobrush.
 Unlock the cover on the side of the
Electrobrush so that the  symbol
becomes visible a.
 Lift the cover up as far as it will go b.
 Remove the roller brush c.
 Remove the roller brush handle if you
identify heavy soiling there d.
 Clean the roller brush and the roller
brush handle, and remove any
stubborn soiling inside the
Electrobrush.
 Reassemble the Electrobrush in
reverse order.
en-CA
31