Miele HS19 Mode D'emploi page 144

en-US
 Reinsert the pre-filter in the dust con-
tainer and turn the pre-filter back to
its original position (Figs. 41 + 42).
 Replace the dust container on the
PowerUnit connector.
Cleaning the Electrobrush/handheld
brush (depending on model) (Fig. 43)
 Disconnect the Electrobrush/hand-
held brush from the vacuum cleaner
(Fig. 10).
 Place the Electrobrush/handheld
brush upside down on a level, clean
surface.
 Use a pair of scissors to cut any
threads or hairs that have wound
themselves around the roller brush. To
guide the scissors, move along the
guide track on the roller brush.
Then run the vacuum cleaner to vacuum
up the cut threads and hairs.
If the small running wheels are very
heavily soiled or blocked, you can re-
move them for easier cleaning (not
necessary in the case of the handheld
brush). To remove them, use a flat-
head screwdriver.
Removing the roller brush from the
Electrobrush (Fig. 44)
(Not possible with the handheld brush)
You can take the roller brush out of the
Electrobrush in order to remove stub-
born soiling and clean the inside of the
Electrobrush.
 Unlock the flap on the side of the
Electrobrush so that the  symbol
becomes visible a.
 Lift the flap up as far as it will go b.
 Remove the roller brush c.
144
 Remove the roller brush handle if you
identify heavy soiling there d.
 Clean the roller brush and the roller
brush handle, and remove any stub-
born soiling inside the Electrobrush.
 Reassemble the Electrobrush in re-
verse order.
Replacing the rechargeable battery
An original Miele AP01/AP02/AP03
lithium-ion rechargeable battery (HX LA)
is required.
Follow the instructions regarding the
handling and disposal of rechargeable
batteries found in the following sec-
tions: "IMPORTANT SAFETY IN-
STRUCTIONS", "Caring for the envi-
ronment", and "Installation and con-
nection" ("General battery informa-
tion").