Zumtobel LINETIK Manuel D'utilisation page 6

Questions about LINETIK
LINETIK Lighting Management FAQ
►Motion sensor does not function
→
Dim value set too low, luminaire switches off
→
Brightness in the room too high, luminaire switches off
►Light sensor does not function
→
Automatic mode deactivated
►Setting of the dim value
→
Do not influence or cover the light sensor when setting the dim value
►Luminaire switches itself on
→
Lighting level in the room is below the set brightness value
→
Motion sensor reacts to detected motion in the room
→
Motion sensor reacts to a fast change of heat in the room
(for example, as well as persons, printers, radiators etc. can also be detected as
motion)
►Luminaire does not switch on
→
Check voltage supply of the luminaire
→
Check mains adapter of the luminaire
→
Luminaire or LINETIK Lighting Management defective
→
Recommendation: Contact Service
5 EN
For questions about LINETIK Lighting Management, please contact:
Zumtobel Lighting GmbH
Schweizer Strasse 30
6850 DORNBIRN
ÖSTERREICH / AUSTRIA
For general information about our products, please refer to our website,
www.zumtobel.com or contact the respective contract partner. If you have
any special questions, please contact your sales partner.
LINETIK lighting management
Article no.: 00154783/PB 03.17