Zumtobel LINETIK Manuel D'utilisation page 3

Operation
Operation
Switch on luminaire
Switch off luminaire
(standby)
Adjust illuminance
manually (dim)
Adjust illuminance
separately manually
(dim)
► To change the direction of the adjustment, release the button and press again and keep pressed.
After longer absence (hold time) or after any power failure, the programmed desired value for the constant
light control is restored automatically.
Article no.: 00154783/PB 03.17
The operation of LINETIK is performed using buttons on the luminaire:
Briefly press key
once
Briefly press key
once
Press and hold key
until the desired
illuminance level is set.
(►)
This is saved as
desired value of the
constant light control
and is reset again
during standby
Status LED in the
sensor
(flashes green or red)
Press and hold key until
the desired illuminance level
is set.
(►)
This is saved as desired
value of the constant light
control and is reset again
during standby
Status LED
extinguishes
Status LED flashes
green
Press and hold key
until the desired
illuminance level is set.
(►)
Constant light control is
temporary deactivated.
Current dim level is kept
and is reset again
during standby.
2 EN