Luminaire Set-Up - Zumtobel LINETIK Manuel D'utilisation

Lighting management
Functions of LINETIK
The desired value
for the illuminance
can be changed and
the constant light
control activated/
deactivated using
the remote control.
The run-on time can
be adjusted and the
presence detection
can be deactivated
using the remote
control.
The lockout can be
activated/deactivate
d and switching
between completely
automatic and semi-
automatic can be
performed using the
remote control.

Luminaire set-up

To ensure optimal
functioning of the
system, ensure that
the sensors are
allocated to the work
area when setting up
the luminaire
.
1 EN
The functions of LINETIK lighting management guarantee high comfort at the
workplace and can significantly reduce the energy consumption.
Constant light regulation
The constant light control of the LINETIK lighting management automatically
adapts the lighting to the lighting conditions at the workplace (sunshine,
overcast sky, closed Venetian blinds). A brightness sensor compares the
illuminance on the work area with an adjustable desired value for this. If
illuminance is not sufficient, the lacking light quantity is adjusted upwards. If
there is too much light, the luminaire is adjusted downwards. In doing do, the
adjustment is performed with a certain inertia to prevent too fast and thus
unpleasant change of the illuminance.
Motion detection
The luminaire is switched on and off automatically using the motion detection.
A passive infra-red sensor (PIR) monitors the detection range for this
(diameter approx. 3.5 m). The luminaire is switched on automatically as soon
as any person is located in the detection range. However, if the constant light
control registers illuminance above the individually adjustable desired value,
the luminaire remains in standby mode. If no person is registered in the
detection range within an adjustable run-on time the luminaire automatically
switches to the standby mode.
Lockout (Power-up) and Automatic
The use of the luminaire at switchable power outlets can be optimised using
the lockout (power-up). When Lockout is activated (Power-up Off), the
luminaire remains in standby mode after any power failure until presence is
detected or it is switched on manually. When Lockout is deactivated (Power-
up On), the luminaire switches on automatically after any power failure.
The LINETIK lighting management enables the completely automatic
operation of luminaries at the workplace without any intervention of the user
being necessary. When semi-automatic (PIR off only) is activated, the
luminaire is in fact switched off during absence, however switching on the
luminaire must be performed manually. As a result, maximum energy saving
is possible. Unintended, automatic switching on (e.g. in areas near corridors)
is prevented.
LINETIK lighting management
Detection range of the
presence detection
approx. diameter 3.5 m
Article no.: 00154783/PB 03.17