Zumtobel LINETIK Manuel D'utilisation page 5

PIR active
(default)
Time delay 1 min
Time delay 10 min
Time delay 20 min
If vacant 0 min
If vacant 1 min
If vacant 30 min
If vacant continuous
Sec. Level 1%
Sec. Level 10%
Sec. Level 30%
DSI
DALI
Power Up ON
(default)
Power Up OFF
To restore the factory settings,
press the DSI button on the remote control five
times.
The direct light flashes for confirmation.
Article no.: 00154783/PB 03.17
Activate motion detection
→ The lighting is automatically switched on and off depending on
whether presence is detected
The run-on time is also set to 20 minutes
Setting of the run-on time to 1 minute
→ Lighting is dimmed to the Sec. Level (absence value) 1 minute
after the last motion detection
Setting of the run-on time to 10 minutes
→ Lighting is dimmed to the Sec. Level 10 minutes after the last
motion detection
Setting of the run-on time to 20 minutes
→ Lighting is dimmed to the Sec. Level 20 minutes after the last
motion detection
Setting of the switch-off delay to 0 minutes
→ Lighting is switched off immediately after the end of the run-on
time
Setting of the switch-off delay to 1 minute
→ Lighting is switched off 1 minute after the end of the run-on time
Setting of the switch-off delay to 30 minutes
→ Lighting is switched off 30 minutes after the end of the run-on time
Setting of the switch-off delay to "infinite" (neverOFF)
→ Lighting is not switched off after the end of the run-on time
Setting of the absence value to 1% = dim level, to which the lighting
will be dimmed after expiry of the run-on time, only applicable if "if
vacant" ≠ 0 min
Setting of the absence value to 10 % = dim level, to which the lighting
will be dimmed after expiry of the run-on time, only applicable if "if
vacant" ≠ 0 min
Setting of the absence value to 30 % = dim level, to which the lighting
will be dimmed after expiry of the run-on time, only applicable if "if
vacant" ≠ 0 min
Press once: Deactivate test mode
Press twice: Activate test mode (status LED flashes red)
Press five times: Factory reset (direct light flashes for confirmation)
Press once: Activate lighting control
Press three times: Deactivate light control permanently (direct light
flashes for confirmation)
Mains power restored activated
→ Luminaire switches on again after a power failure
Mains power restored deactivated
→ Luminaire does not switch on again after a power failure
4 EN