Publicité
4. Installation Instruction
Assembly instructions: before assembly, please check whether the accessories are
complete according to the parts drawing. The gross weight of the product is 28KG, the net
weight is 25kg, the base area is 64cm * 100cm, and the height of the whole vehicle after
installation is 120cm. It is recommended that two or more personnel cooperate to install in
the open space
1. Take out the front foot tube and put it into the strip hole at the rear of the frame.
Insert the flat pad Ф 8 and the spring washer Ф 8 on the bolt in turn, then put on the
cover nut and lock it with our special open-ended wrench. (the installation method of
rear foot tube is the same as above. )
(Note: after the installation of the front and rear pins, the product may have three feet
on the ground. At this time, the height of the black leg cover on the pin can be adjusted
to balance the product.)
2、 Take out the pedal, you will find that there are "L" and "R" on the pedal, take out the pedal with
"R", take down the nut on the pedal, and then turn it into the right crank threaded hole, rotate
part clockwise un�l it can't be turned, then lock it with our special open-end wrench, and finally
screw in the nut a li�le by hand, and then �ghten the nut with our open-end wrench. Take out the
"L" pedal, take off the nut, turn it into the le� crank threaded hole, turn part of it an�clockwise
un�l it can't be turned, then lock it with our special open-end wrench, and finally screw in the nut
a li�le, and then �ghten the nut with our open-end wrench.
(Note: the crank is also marked with "L" and "R", which is corresponding to the mark on the pedal.
If it is installed in reverse, the product may be damaged by the crank sliding thread. And the pedal
must be locked, otherwise the pedal may fall off a�er a long �me of use, and the nut is also
divided into le� and right sides, "L" pedal corresponds to the inner ring with blue an�-skid nut, "R"
pedal corresponds to the inner ring with white an�-skid nut)
Note: the pedal in the schema�c diagram may be different from the real object. This picture is for
illustra�on。
10
Publicité
