Hatco Glo-Ray Série Manuel D'installation Et D'utilisation page 17

English
Changing the Setpoint Temperature — Mechanical
Temperature Control
Turn the temperature control clockwise to increase the setpoint
temperature. Turn the temperature control counterclockwise to
decrease the setpoint temperature.
Power I/O (on/off) Switch
Temperature Control
Mechanical Temperature Control—Small Control Box
Changing the Setpoint Temperature — Digital
Temperature Controller
Units equipped with a digital temperature controller will heat up to
the setpoint temperature automatically when they are turned on.
Use the following procedure to change the setpoint temperature.
NOTICE
Built-in units must not have a setpoint temperature higher
than 200°F (93°C). Temperatures exceeding 200°F will
damage unit and void warranty.
NOTE: The temperature shown on the (temperature) display
may be inaccurate when unit temperature is below
130°F (54°C).
1. Press the key three times. The current setpoint
temperature will be shown on the
("SP" will be displayed after the second press).
2. Press the key or
the setpoint temperature.
Small Control Box Installation Dimensions
6-3/4"
(171 mm)
Digital Temperature
Controller
3-3/4" (95 mm)
Mechanical Temperature
Control
3-7/16" (87 mm)
9-7/16"
(240 mm)
Front View of Cutout
Form No. GRSSM-1020
(temperature) display
key within 10 seconds to change
Digital Temperature Controller
3-1/4" (83 mm)
Mechanical Temperature Control
2-15/16" (75 mm)
OPTIONS AND ACCESSORIES
3. Press the key to lock in the new setpoint temperature.
The (temperature) display will go blank for two seconds
to show that the new setting has been accepted.
NOTE: After 10 seconds of inactivity during the programming
process, the controller will exit programming mode
automatically without saving any changes.
Set Key Up Arrow Key
Display Down Arrow Key
Digital Temperature Controller—Small Control Box
Changing Fahrenheit and Celsius Setting — Digital
Temperature Controller
Use the following procedure to change between Fahrenheit and
Celsius on the display.
1. Press the key once. Either an "F" for Fahrenheit or "C"
for Celsius will be displayed.
2. Press the key or
between "F" (Fahrenheit) and "C" (Celsius).
3. Press the key three times to lock in the new setting.
The (temperature) display will go blank for two seconds
to show that the new setting has been accepted.
NOTE: After 10 seconds of inactivity during the programming
process, the controller will exit programming mode
automatically without saving any changes.
Side View of Installed Enclosure
17
Power I/O (on/off)
Switch
key within 10 seconds to change
2-3/4"
(69 mm)
Control Enclosure
Mounting Surface