Hatco Glo-Ray Série Manuel D'installation Et D'utilisation page 15

Masquer les pouces Voir aussi pour Glo-Ray Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Flush Remote Mounted Control Enclosures
(GRSSB Models only)
Two flush-style remote mounted control enclosures are
available for the GRSSB model — the Mechanical Temperature
Control enclosure and the Digital Temperature Controller
enclosure. Both enclosures are installed using the following
procedure.
WARNING
ELECTRIC SHOCK HAZARD: Remote mounted control
enclosure must be mounted on a vertical wall and
installed in vertical position. Mounting control enclosure
in horizontal position may result in collection of liquids
and lead to an electric shock.
NOTICE
Install remote mounted control enclosure outside of heat
zone. Locating control enclosure inside heat zone will
cause control(s) to overheat, malfunction, and fail.
Do not modify wiring or cut thermostat capillary on
control box to increase remote mounting distance. Cutting
thermostat capillary will cause unit to overheat and may
damage unit as well as surrounding countertop.
NOTE: A qualified electrician is recommended for connecting
the units to a power source.
1. Prepare cutout and pre-drill screw holes.
2. Remove trim cover from control enclosure assembly.
3. Position control enclosure into opening through the
backside.
4. Secure control enclosure to mounting surface using screws
(not supplied).
5. Connect proper power source to the mounted remote
control enclosure.
6. Reinstall trim cover.
NOTE: Units are equipped with a 3' (914 mm) flexible conduit
connecting the control enclosure to the unit. The digital
temperature controller also offers 6' (1829 mm) and 10'
(3048 mm) conduit lengths.
5-7/8"
(149 mm)
6-7/8"
(174 mm)
3-7/8"
(98 mm)
Front View of Cutout
Form No. GRSSM-1020
IMPORTANT NOTE:
Make sure the installation
location provides enough
room
connections to the control
enclosure.
6-3/8"
(162 mm)
Optional Remote Mounted Control Enclosure Installation Dimensions
OPTIONS AND ACCESSORIES
Power I/O (on/off) Switch
Both flush-style remote mounted control enclosures are
equipped with a Power I/O (on/off) switch. Move the Power
I/O (on/off) switch to the I (on) position to turn on the unit. The
indicator light in the switch glows when the unit is on.
Changing the Setpoint Temperature — Mechanical
Temperature Control
Turn the temperature control clockwise to increase the setpoint
temperature. Turn the temperature control counterclockwise to
decrease the setpoint temperature.
Temperature Control
Power I/O (on/off) Switch
Mechanical Temperature Control
Digital Temperature Controller
Mechanical Temperature Control
for
electrical
Trim Cover
Side View of Installed Enclosure
15
4-3/4" (121 mm)
4" (102 mm)
Control Enclosure
Mounting Surface

Publicité

Chapitres

Table des Matières
loading

Table des Matières