Publicité
User manual
DESCRIPTION OF THE EQUIPMENT (II)
1-
Reel support Ø 200/300 mm
2-
Wire-feed motor
3-
Cover for coolant outlet (Blue)
4-
Cover for coolant inlet (Red)
5-
Euro connector (torch)
6-
HMI (Human Machine Interface)
7-
Torch support
HUMAN-MACHINE INTERFACE (HMI)
Please read the Interface User Guide (HMI) which forms part of the complete product literature.
HMI
POWER SWITCH
This equipment has been designed to work exclusively with the GALAXY range of power sources:
GALAXY 400T DUO
080850
GALAXY 400T G
080829
GALAXY 400T GW
080843
The connection between these two parts is made through a dedicated interconnection cable, available separately:
Type of torch cooling
Air
Water
ATTACHING THE INTERCONNECTION CABLES
Make sure the main welding power source switched off when connecting or disconnecting the wire feeder. Ensure the machine is
unplugged from the mains, and then wait 2 minutes.
For attaching the interconnection cable between the power source and the wire feeder, refer to pages 3 or 4.
SETTING UP THE REEL
a
b
b
a
Translation of the original
instructions
Length
Section
5 m
70 mm²
70 mm²
10 m
95 mm²
15 m
95 mm²
20 m
95 mm²
1.8 m
70 mm²
5 m
70 mm²
70 mm²
10 m
95 mm²
15 m
95 mm²
20 m
95 mm²
- Remove the nozzle (a) and contact tube (b) from your MIG/MAG torch.
- Open the wire feeder cover.
- Position the reel on its holder.
- Take into consideration the reel stands's drive lug (c). To fit a 200 mm reel, tighten the
plastic reel holder (a) to the maximum.
c
- Adjust the brake wheel (b) to prevent the non-moving spool from tangling the wire when
the welding stops. Do not over tighten as this will cause the power source to overheat.
8-
Interconnection cable connector
9-
Gas inlet
10-
Power relay connector
11-
Interconnection support
12-
Transport handles
13-
Turret (pivot)
14-
USB connection
Reference
075443
075450
077553
082083
082090
075467
To ensure optimum welding in Pulse mode, we
075474
recommend not exceeding 10 m beam length.
075481
075504
079816
082106
WF 36
21
Publicité
