Publicité
8
INSTALLING YOUR BEVERAGE CENTER
Reversing The Door Hinge
1. Remove the top hinge cover.
2. Using a Phillips Head Screwdriver, loosen and remove the 2 screws holding
the top hinge in place.
3. Remove top hinge and carefully lift o the door.
4. Remove the screw hole plugs from the opposite side of the cabinet and the
door and insert the plugs in the screw hole openings of the just removed
screws.
5. Remove any loose items in the wine cellar and carefully place the wine cellar
on its back.
6. Loosen the screws holding the lower hinge bracket to the wine cellar and
remove screws and bracket.
7. Remove (2) screws from the other side and insert in the previously removed
screw holes. Tighten the screws.
8. Remove the door pin from the lower hinge bracket by turning it counter-
clockwise. Turn over the bracket, then reinsert the door pin into the threaded
hole, and tighten.
9. Align the door with the cabinet first. Then install the lower hinge bracket to
the bottom opposite side of the cabinet. Then insert (2) remaining screws
into the holes. Tighten the screws.
10. Align top hinge bracket with screw holes, insert screws and partially secure,
check that door and cabinet are properly aligned and then secure tightly.
11. Align upper hinge bracket with screw holes insert screws and partially secure,
check that door and cabinet are properly aligned and then secure tightly.
12. Place the unit back in an upright position. Replace the top hinge cover.
NOTE: If the top of the door is not aligned with the cabinet, loosen the top
hinge screws, adjust door and re-tighten the screws.
Top hinge and
hinge cover
Lower hinge bracket
Cabinet hole plug Cabinet hole plug
Door Pin
Turn over
Top hinge and
hinge cover
Door Pin
Lower hinge bracket
EN
Publicité
