Publicité
10
PROPER BEVERAGE CENTER CARE & CLEANING
Cleaning and Maintenance
Warning:
Caution:
General:
Door Gaskets:
Defrosting Your Beverage Center
Your Beverage Center is designed with a manual defrost system. The Beverage Center
surfaces will defrost, when the unit is unplug. Water from the unit is disposed of
automatically, by means of being channeled onto a drip tray located on the compressor.
Heat transfer from the compressor causes this water to evaporate.
Power Interruptions
•
Occasionally there may be power interruptions due to thunderstorms or other causes.
Remove the power cord from AC outlet when a power outage occurs. When power
has been restored, replug power cord to AC outlet.
•
The unit will revert to the factory setting of 46
temperature selection.
Vacation and Moving Care
•
For long vacations or absences, empty contents from Beverage Center, unplug the
unit and clean the Beverage Center and door gaskets according to "General cleaning"
section. Prop doors open, so air can circulate inside. When moving, always move the
Beverage Center vertically. Do not move with the unit lying down. Possible damage to
the sealed system could occur.
To avoid electric shock, always unplug your beverage center
before cleaning. Ignoring this warning may result in death
or njury.
Before using cleaning products, always read and follow
manufacturer's instructions and warnings to avoid personal
injury or product damage.
•
Prepare a cleaning solution of 3-4 tablespoons of baking soda
mixed with warm water. Use sponge or soft cloth, dampened
with the cleaning solution, to wipe down your beverage center.
•
Rinse with clean warm water and dry with a soft cloth.
•
Do not use harsh chemicals, abrasives, ammonia, chlorine bleach,
concentrated detergents, solvents or metal scouring pads. Some
of these chemicals may dissolve, damage and/or discolor your
Beverage Center.
•
Clean door gaskets every three months according to general
instructions. Gaskets must be kept clean and pliable to assure a
proper seal.
•
Petroleum jelly applied lightly on the hinge side of gaskets will
keep the gasket pliable and ensure a good seal.
°
F after any power outage. Reset your
EN
Publicité
