Publicité
EN
INSTALLING YOUR BEVERAGE CENTER
Using Your Beverage Center
Startup
Connect the power cord to a standard wall outlet. Do not use a GFCI outlet
to connect the unit (see page 4). After connection, you will immediately hear
a short beep.
Temperature-Adjustable Thermostat Control
The default temperature is 43°F. Use the
temperature between the range of40°F-61°F.
The display will flash while the temperature is being set. After a few seconds
it will revert to its current internal temperature reading The digital display
reading will adjust as the unit cools.
While the unit is adjusting to the new setting, press the
view the selected temperature setting.
If there is a power outage, the unit will revert to the last temperature setting
once power is restored.
Loading Beverages
When first loading the beverage center to full capacity, we recommend the
following steps to e ectively cool a large number of beverages.
1. Use the Adjustable Thermostat Control to set the temperature to 43°F (also
the default temperature).
2. Allow the beverage center to cool for a minimum of two hours.
3. Load the beverages. To achieve maximum capacity, refer to the loading
diagrams.
4. After initially filling with beverages the internal temperature will rise as
indicated on the display.
5. Once the beverage center has cooled the beverages to 43°F, use the
Adjustable Thermostat Control to select a desired cooler internal
temperature (lowest temperature setting is 40°F).
6. Allow several hours for the beverage center to cool to the desired lower
temperature.
Note: It is normal for temperature variances to occur inside the unit, and areas
near the door will have slightly warmer temperatures.
and
buttons to set the desired
or
7
buttons to
Publicité
