Publicité
EN
INSTALLING YOUR BEVERAGE CENTER
Unpacking Your Beverage Center
1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the beverage center accessories inside and outside.
2. Inspect and remove any remaining packing, tape or printed materials
before powering on the Beverage Center.
Leveling Your Beverage Center
• Your Beverage Center has two leveling legs which are located in the front
corners. After properly placing your Beverage Center in its final position,
you can level your Beverage Center.
• Leveling legs can be adjusted by turning them clockwise to lower your
Beverage Center or by turning them counterclockwise to raise your
Beverage Center. The Beverage Center door will close more easily when
the two front leveling legs are extended slightly.
Proper Air Circulation
• To ensure that your Beverage Center works at the maximum e ciency it
was designed for, you should install it in a location where there is proper air
circulation and electrical connections.
• The following are recommended clearances around the beverage center:
Sides...............2" (50mm)
Top....................2" (50mm)
Back..................2" (50mm)
• Do not over fill your Beverage Center for proper cooling.
Note: If your Beverage Center has been tilted for any reason, wait 24 hours
before plugging it in.
Drip Tray
• Ensure the drip tray in the rear of the unit is in the proper position.
5
Publicité
