Télécharger Imprimer la page

Haier HCW58F18EWMP Manuel D'utilisation page 9

Publicité

GB
WARNING!
Do not touch the inside surface of the freezer storage compartment
when in operation, especially with wet hands, as your hands may
freeze onto the surface.
Unplug the appliance in the event of a power interruption or before
cleaning. Allow at least 7 minutes before restarting the appliance, as
frequent starting may damage the compressor.
WARNING: Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
Maintenance / cleaning
Make sure children are supervised if they carry out cleaning and
maintenance.
Disconnect the appliance from the electrical supply before under-
taking any routine maintenance. Allow at least 5 minutes before
restarting the appliance, as frequent starting may damage the
compressor.
Hold the plug, not the cable, when unplugging the appliance.
Do not clean the appliance with hard brushes, wire brushes, detergent
powder, petrol, amyl acetate, acetone and similar organic solutions,
acid or alkaline solutions. Please clean with special refrigerator /freezer
detergent to avoid damage. Eventually use warm water and baking
soda solution - about a tablespoon of baking soda to a litre/quart of
water. Rinse thoroughly with water and wipe dry. Do not use cleaning
powders or other abrasive cleaners. Do not wash removable parts in
a dishwasher.
Do not scrape off frost and ice with sharp objects. Do not use sprays,
electric heaters like heater, hair dryer, steam cleaners or other
sources of heat in order to avoid damage to the plastic parts.
WARNING: Do not use mechanical devices or other means to
accelerate the defrosting process, other than those recommended
by the manufacturer.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
Do not try to repair, disassemble or modify the appliance by yourself.
In case of repair please contact our customer service.
If the illuminating lamps are damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
Safety information
7

Publicité

loading