Publicité
16. Disposal and recycling
On removal of the machine the local legal regulations
have to be abided by.
Please contact the manufacturer in case of disposal.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing
to the effective use of natural resources. You can
obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
17. Troubleshooting
Problem
Possible Cause
Saw blade gets loose
1. Fastening nut tightened
after turning off the
insufficiently
motor
Motor does not start.
1. Failure of mains fuse
2. Extension cable defective
3. Connections at the motor or switch
out of order
4. Motor or switch defective
Motor does not work,
1. Cross-section of the extension
the fuse responds
cable is not sufficient
2. Overload due to blunt saw blade
Burnt areas on the
1. Blunt saw blade
cutting surface
2. Incorrect saw blade
The saw does not
1. Mechanical brake is defective
brake when switching
the machine off
Motor runs erratically
1. Switch defective
2. Extension cable defective
Overheated engine
1. Air flow restricted.
m Electrotechnical maintenance works should only be carried out by an electronics technician!
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Help
1. Tighten fastening nut, right-handed thread
1. Check the mains fuse.
2. Replace defective extension cable
3. Check with the help of an electrician
4. Check with the help of an electrician
1. Refer to Electrical Connection
2. Replacing the saw blade
1. Sharpen/replace saw blade
2. Replace saw blade
1. Have the brake replaced.
1. Contact the service department
2. Replace extension cable / have this checked by an
electrician.
1. Do not cover the drive motor with objects.
GB
27
Publicité
