Publicité
Keep oils and lubricants out of reach of unauthor-
ised persons. Read through the instructions on the
containers carefully and follow them closely. Avoid
direct contact with the skin and wash off thoroughly
after use.
m Check all safety devices after maintenance
and cleaning work.
Maintenance
Turn the engine off and let the engine cool down.
Re-fit the mains plug.
Check the general condition of the machine. Be care-
ful with loose screws, misaligned or moving parts,
breakage of parts, and any other condition that could
interfere with safe operation.
Remove any foreign objects and other materials
that have accumulated on the saw blade and the
unit. Clean the machine after each use. Then use a
high-quality and thin fluid machine oil to lubricate all
moving parts.
m Never use a "pressure washer" to clean your
unit. Water can penetrate tight areas of the
machine and its transmission case and cause
damage to spindles, gears, bearings, or the
engine. The use of pressure washers will result
in shortened life and reduce serviceability.
Experienced craftsmen can perform minor repairs
on the machine itself.
• Check the saw blade regularly. Use only
well-sharpened, crack-free and not distorted saws.
Use only tools that comply with the European
standard EN 847-1.
• Exchange immediately rocker that run out.
• Check all safety installations after each mainte-
nance and cleaning activities.
• Ensure that there are no tools or other materials on
or in the machine before putting it into operation.
• Remove possible sawdust blockages at the dis-
charge.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use
as consumables.
Wear parts*: sawblade; seesaw inserts
* Not necessarily included in the scope of delivery!
26
GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
15. Exchange of saw blade
1
• The exchange of the saw blade can only be under-
taken in firewood cut position.
• Loosen the top and bottom screws on the protec-
tive cover approx. 5 mm and open the protective
cover.
• To lock the saw blade into place, insert the locking
pin (1) through the corresponding opening on the
saw blade guard. To do this, insert the pin com-
pletely and straight into the hole. Use the corre-
sponding hole (depending on the saw blade type)
so that the pin is at the lowest point (bottom of the
tooth).
• Loosen the saw blade with the supplied open-end
spanner / Allen wrench (2).
• Remove the saw blade flange
• Insert the new saw blade.
• Mount the saw blade flange again and tighten the
clamp screw.
• Remove the locking pin.
m Attention! When installing the saw blade, pay
attention to the correct direction of rotation!
2
Publicité
