Publicité
necessary, you should seek the advice of an
expert�
When deciding where to mount the
light, pay attention to the following:
Ensure the product illuminates the desired
„ „
area� Make sure that the motion sensor
covers the desired area�
The motion sensor has a maximum
„ „
detection range of 10m with a field of view
of approx� 120°�
Ensure that the motion sensor
„ „
position where street lighting will shine on it
at night� This may impair the function�
The recommended installation height is 2 to
„ „
4m� If possible, mount the Spotlight in a
position where it will not be exposed to dirt
or dust and is protected from rain (e�g�
under a roof overhang) and other
weathering effects�
Please note: the solar panel
positioned where it will be exposed to as
much direct sunlight as possible� Even partial
shade during the day can significantly
impair the charging process�
Orientation:
The optimum alignment is facing south�
Choose an orientation facing slightly to the
west rather than slightly to the east�
z Mounting the Spotlight
Transfer the positions of the guide holes
„ „
to the mounting point on the wall (see Fig� A)�
Drill two holes (dia� 6mm) and insert the
„ „
matching wall plugs
and G)�
Screw the screws
„ „
7
leaving a gap of approx� 3mm between the
screw head and the wall (see Fig� C)�
Slot the guide holes
„ „
then slide the Spotlight along the guides to
fix it in place (see Fig. C).
If necessary, adjust the gap between the
„ „
screw heads and the mounting surface to
provide a firm seating for the Spotlight.
4
is not in a
4
should be
2
3
(see Figs� C
8
into the wall plugs
8
over the screws and
3
Mounting Model 1262-S with a spacer
You have the option of mounting the Model
1262-S with a spacer (see Fig� E) (see above
for mounting without a spacer)�
Screw the spacer
„ „
floodlight using the screws
Screw the spacer
„ „
inserting the screws
holes
into the wall plugs
12
tightening them (see Fig� G)�
z Positioning the Spotlight/
solar panel
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig� D)�
Loosen the two Spotlight star knobs
„ „
adjust the Spotlight (see Fig� B)�
When the desired position is obtained,
„ „
tighten the star knobs again� If necessary,
use a screwdriver to hold the screw while
tightening the star knob (due to the design,
we recommend using an offset screwdriver)�
Positioning model 1262-S with a spacer
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig� H)�
Loosen the spacer star knob
„ „
the height of the floodlight (see Fig. H).
When the desired position is obtained,
„ „
tighten the star knob again�
Loosen the Spotlight star knob
„ „
the angle (see Fig� H)�
When the desired position is obtained,
„ „
tighten the star knob again� If necessary,
,
use a screwdriver to hold the screw while
tightening the star knob (due to the design,
we recommend using an offset screwdriver)�
Please note: the motion sensor has a field
of view of up to 120°� Make sure that the
motion sensor faces directly towards the
desired detection zone�
securely onto the
9
(see Fig� F)�
11
securely in place by
9
through the guide
7
and firmly
8
to
6
to adjust
10
to adjust
6
GB
33
Publicité
