Publicité
Brush Roller Self-cleaning
Brush Roller Cover
②
Squeeze latches on the cover and pull upward
to remove.
While replacing, always latch the brush cover
into place to avoid leakage.
1. Place the appliance on the charging dock after use,
the sensor will auto-detect the level of dirt.
2. When you hear the voice prompt "please start self
cleaning", press the self-cleaning button and begin
the process.
3. Once complete, you will hear the voice prompt "self
cleaning completed, please clean the Dirty Water
Tank." At this point, the appliance will begin charging..
Note:
• Ensure the charging dock is plugged in and the battery
level>30%.
• Before self-cleaning cycle, please clean the DWT and
ensure the water level in the CWT>40%.
• During the drying process, if you press the self-cleaning
button, the drying process will be interrupted. You can
press it again to restart self-cleaning.
①
Wipe with a wet cloth.
46
Publicité
