29 I TASKA CX Hand User Guide
Button panel overview
A
A - CYCLE
B - HOME
SHORT PRESS (<1 SECOND)
Cycle through up to 5 grips
Home Grip 1
(default are Flexitool,
(default is General
Tripod, Key)
Grasp)
LONG PRESS (>1 SECOND)
Audio on/off
Home Grip 2
(default is Pincer)
EXTRA LONG PRESS (>4 SECONDS)
-
Power
Your hand will automatically turn
on when the power is supplied.
Please refer to the relevant user
manual for power system operation.
As your hand turns on, lights on the
button panel will flash briefly and
B
C
C - LOCK
Lock/unlock device
Bluetooth® on/off
-
Activate Bluetooth
pairing mode
the fingers will open for calibration.
Ensure the fingers are free to open
fully and calibrate correctly.
Warning lights
If the warning light (
) comes
on, there is a problem with the
hand. Turn the power off and on
again (power cycle). If the light still
appears, contact your clinician.
The Low Battery light ( ) will flash
if there is less than 10% battery life
remaining.
Bluetooth
Bluetooth ( ) can be turned on
and off by holding down the Lock
Button for 1 second (long press).
Overblik knappanel. Se diagrammerne på side 29 for at
DA
få hjælp.
A - GENNEMGÅ
B - HJEM
KORT TRYK (<1 SEKUND)
Gennemgå op til 5 gribere
Hjem Griber 1
(standard er Flexitool,
(standard er General
Tripod, Key)
Grasp)
LANGT TRYK (>1 SEKUND)
Audio on/off
Hjem Griber 2
(standard er Pincer)
EKSTRA LANGT TRYK (>4 SECONDS)
-
Strømforsyning
Din hånd tændes automatisk, når
strømmen tilføres. Se venligst den
relevante brugsvejledning for drift
af strømsystemet.
Når din hånd tændes, blinker
lysene på knappanelet kort,
og fingrene åbnes for kalibrering.
TASKA CX Hand User Guide I 30
MyTASKA app
All grips and selected sensor
settings are user configurable
using the MyTASKA app. The
app can be downloaded to your
Android or iOS device from the
appropriate app store. Follow the
on screen instructions and refer
to the TASKA website for further
information.
C - BLOKER
Bloker/frigør enhed
Bluetooth® on/off
-
Aktiver parringstilstand
Bluetooth
Sørg for, at fingrene er frie, så de
kan åbne sig helt og blive korrekt
kalibrerede.
Advarselslys
Hvis advarselslyset (
) tænder,
er der opstået et problem med
hånden. Sluk for strømmen og
tænd igen (strømcyklus). Hvis
EN
DA