Health O Meter Professional 2900KL-AM Mode D'emploi page 9

DISPLAY HEAD WALL MOUNT INSTRUCTIONS (CONT)
5. Once the holes are drilled,
use a hammer or Phillips
head screwdriver to set the 2
drywall anchors into the
holes. Use a screwdriver to
insert the drywall anchors
completely into the wall.
Screw the two mounting
screws into the anchors.
Adjust the screw head depth
so the screw heads protrude
1/8" (3.2 mm) from the wall.
Warning: Extending the
screw heads beyond 1/8"
(3.2 mm) can damage the
display assembly.
6. Obtain the display head and
the load cell cable. Feed the
load cell cable through the slot
in the bracket as shown. Plug
the load cell cable into the
load cell port on the rear of the
display head.
7. Plug the other end of the load
cell cable into the port on the
side of the scale pillar. The
display head can be mounted
to the right or the left of the
scale.
8. See Powering the Scale on the
next page for battery/AC
adapter instructions.
p osition the mounting bracket
holes onto the mounting
screws, and carefully pull
down on the display head to
secure.
The scale is now ready to use.
82-00014 2900KL-AM 2900KG-AM REV B
Then
9