Trumpf TruConvert AC 3025 Manuel Opérateur page 90

Addr Description
4008 Alarm policy for modules:
0 = strict (system swit-
ches to alarm state if at
least one module is in
alarm state)
1 = relaxed (system swit-
ches to alarm state if all
modules are in alarm
state)
4009 Grid type:
0 = grid-tied, 400V, 50Hz
1 = grid-tied, 480V, 60Hz
2 = island mode, 400V,
50Hz
3 = island mode, 480V,
60Hz
4 = grid-tied, 380V, 60Hz
4010 Specifies the sub slave
that will be addressed (0
= broadcast / same
values for all sub slaves)
4011 Use the modbus slave ID
for addressing
4012 Alarm policy for sub-
modules:
0 = strict (AC-DC module
switches to alarm state if
at least one sub-module
is in alarm state)
1 = relaxed (AC-DC
module switches to alarm
state if all sub-modules
are in alarm state)
2 = off (If possible AC-
DC module continues
operation even if all sub-
modules are in alarm
state)
4182 0 = Power setpoints
become active immedia-
tely
1 = Power setpoints
become active after trig-
ger is set (register 4183)
4183 0 = Idle
1 = Send power setpoints
4184 Switch to change inputs
from S, cosphi, Phase-
Cap to P, Q
84
Manipulation
Unit Res Default
olu-
tion
- 1.0 0
- 1.0 0
- 1.0 0
- 1.0 0
- 1.0 0
- 1.0 0
- 1.0 0
- 1.0 0
Min Max Dat Typ
atyp e
e
UIN Regi
T16 ster
0 4 UIN Regi
T16 ster
0 16 UIN Regi
T16 ster
0 1 UIN Coil
T16
0 2 UIN Regi
T16 ster
0 1 UIN Regi
T16 ster
0 1 UIN Regi
T16 ster
0 1 UIN Regi
T16 ster
2024-08-01
Len FCr FCw
gth
1 03 06
1 03 06
1 03 06
1 01 05
1 03 05
1 03 06
1 03 06
1 03 06
A67-0141-00.BKfr-0
01-11