Publicité
Mud guard set
Scope of delivery
2 x mud guards (230 x 250 mm)
6 x chipboard screws
5 x templates
Intended use
If the original mud guard cannot be used when mounting the
Mover® behind the axle, use the Truma mud guard set and
adapt it if necessary.
The mud guards are installed behind the axle. No mud
guards are required in front of the axle.
Mounting dimensions, mud guards
Fahrtrichtung
Figure 1
Adapting the mud guards to the Mover®
1. Remove the original mud guards
2. Fit the Mover®
3. Determine the dimensions a and b and transfer to the
Truma mud guards.
4. The top leg of the fastening bracket must face towards the
rear of the caravan.
Pay attention to left and right sides!
Determining the cut-out sizes
Mover®
SR Version 2
a
b
Figure 2
max.
300 mm
max. 200 mm
a
Mover® SR2
25
b
Mover® / GO2
Mover® SE R, TE R, TE R 4,
H SE R, H TE R
a
b
Figure 3
Mover® XT, XT2, XT4, XT L
HR XT, HR XT2, HR XT4, HR XT L
a
b
Figure 4
Mover® SX
a
b
Figure 5
GO2 RH 2
a
b
Figure 6
Cut out the supplied template and place it on the mud guard,
transfer the contours and cut out (Figures 4, 5, 6).
Pay attention to left and right sides!
If necessary, make recesses in the mud guard for the apron
contour.
Using the supplied screws, secure the mud guard 300 mm
from the tyre on the underside of the caravan.
a
b
a
Mover®
Mover® XT / XT2
XT / X X
XT2
b
a
b
a
RH 2
(b - 50)
b
Publicité
