MINN KOTA CORDED FOOT PEDAL Manuel Du Propriétaire page 8

FOOT PEDAL OPERATION
AutoPilot
The AutoPilot button is located on the left side of the Foot Pedal, below the Indicator Panel. Pressing the AutoPilot button toggles
AutoPilot on and off. The AUTOPILOT
in both Normal Mode and Ulterra Mode. When AutoPilot is initiated from the Foot Pedal, the default AutoPilot mode is determined by the
paired remote. AutoPilot can also be engaged and disengaged using the remote. For more specific directions on how to use AutoPilot,
refer to your remote Owner's Manual.
Spot-Lock
The Spot-Lock button is located on the lower-right side of the Foot Pedal and is labeled with an anchor symbol. When the Spot-Lock
button is pressed, the location of the motor is recorded to a temporary Spot-Lock location. To engage Spot-Lock, press the Spot-Lock
button. To disengage, press the Spot-Lock button again. The SPOT-LOCK
is engaged. Spot-Lock can be engaged in Normal and Ulterra Modes, and switching between Modes does not cancel Spot-Lock. Spot-Lock
can also be controlled with a remote.
When engaging Spot-Lock, a tone will be emitted from the Control
Head. When disengaging Spot-Lock with the Spot-Lock button,
no tone will be emitted. Steering the motor with the Foot Pedal or
adjusting the speed using the Speed Control Knob will cancel
Spot-Lock, and a tone consisting of several short beeps will emit
from the Control Head.
The Spot-Lock and AutoPilot buttons only work on trolling motors already installed with these features. If the Foot Pedal is
NOTICE:
used on a motor without these features, the Spot-Lock and AutoPilot buttons will be non-functioning.
STOW, DEPLOY & TRIM
STOWING AND DEPLOYING THE MOTOR WITH THE FOOT PEDAL
Use the following procedure to stow and deploy the motor. If the motor stalls when attempting to stow, the motor may be encountering
an error. Check for obstructions or low motor batteries. If the batteries are too low to fully stow the motor, re-engage power, deploy the
motor, trim the lower unit to its highest setting, and turn power off until batteries can be recharged. Once batteries are charged, attempt
to stow the motor again.
1
a. Locate the Indicator Panel at the end of the Mount
on the trolling motor. Ensure that the trolling motor
is powered on. When the motor is on, the System
Ready LED will illuminate green.
8 | minnkota.johnsonoutdoors.com
LED on the Indicator Panel illuminates red when AutoPilot is engaged. AutoPilot can be used
AUTOPILOT
SPOT-LOCK
LED on the Indicator Panel illuminates blue when Spot-Lock
AUTOPILOT
SPOT-LOCK
In the default Audio Mode, a tone is emitted from
NOTICE:
the Control Head when Spot-Lock or AutoPilot is engaged.
If the Audio Mode is changed, a tone will not be emitted
when engaging Spot-Lock or AutoPilot. To learn more about
Audio Modes, refer to the paired remote Owner's Manual
online at minnkota.johnsonoutdoors.com.
Power Button Power Button
Status Status
Indicator Indicator
Indicator Panel on Trolling Motor Mount Indicator Panel on Trolling Motor Mount
System Ready System Ready
Indicator Indicator
ULTERRA
©2023 Johnson Outdoors Marine Electronics, Inc.