MINN KOTA CORDED FOOT PEDAL Manuel Du Propriétaire page 6

USING THE FOOT PEDAL
You are responsible for the safe and prudent operation of your vessel. We have designed the Foot Pedal to be an accurate and reliable
tool that will enhance boat operation and improve your ability to catch fish. This product does not relieve you from the responsibility
for safe operation of your boat. You must avoid hazards to navigation and always maintain a permanent watch so you can respond to
situations as they develop. You must always be prepared to regain manual control of your boat. Learn to operate the Foot Pedal and
trolling motor in an area free from hazards and obstacles.
FOOT PEDAL OPERATION
Motor Speed
The Speed Control Knob is located between the MODE and Spot-Lock buttons on the right side of the Foot Pedal. Turn the Speed Control
Knob forward to increase speed and backward to decrease speed. The Speed Control Knob can be set in a range from 0 to 10. Speed
can be adjusted in both Normal Mode and Ulterra Mode. Speed can also be adjusted using a remote.
Heel/Toe Steering
Push the Toe End of the Foot Pedal down to turn right and push the Heel End of the Foot Pedal down to turn left. The position and
direction of the Control Head directly corresponds to the position of the motor. Use the foot pedal to control the steering direction during
manual operation. Heel/Toe Steering functions the same in Normal Mode and Ulterra Mode. The direction of the motor can also be
controlled with a remote.
Steer Right/Steer Left
The Steer Right and Steer Left
bottom of the Foot Pedal. They function to steer the motor to the
right and left when the Foot Pedal is operating in Normal Mode. The
amber MODE LED on the Indicator Panel will not be illuminated
MODE
when in Normal Mode. Holding the Steer Right or Steer Left buttons
down will continue to steer the motor to the left or right. Small
steering changes of less than one degree can be made by quickly
tapping the Steer Right and Steer Left buttons. The position of the
Steering Head directly corresponds to the position of the motor.
The direction of the motor can also be controlled with a remote.
Trim Down/Trim Up
The Trim Down and Trim Up
of the Foot Pedal. They function to trim the motor up and down
when the Foot Pedal is in Ulterra Mode. The amber MODE
on the Indicator Panel will be illuminated when in Ulterra Mode.
The Trim Down button trims the motor down and the Trim Up
button trims the motor up.
Prop ON/OFF
The Prop ON/OFF button is located at the bottom of the Foot Pedal. It functions to momentarily turn the Prop on and off when the
Foot Pedal is operating in Normal Mode. The MODE
Prop will turn on when pressure is applied to the button and turn off when pressure is removed. The Prop button does not change the
behavior of the Prop when the Constant button is engaged.
6 | minnkota.johnsonoutdoors.com
WARNING
buttons are located at the
buttons are located at the bottom
MODE
LED on the Indicator Panel will not be illuminated when in Normal Mode. The
MODE
The steering system is designed to turn the motor 360 degrees.
Be careful to avoid over-wrapping the Coil Cord around the
trolling motor Shaft.
When trimming the motor, keep fingers clear of all hinges, pivot
points and all moving parts. When stowing and deploying the
motor, ensure that it doesn't contact the boat, trailer, or any
LED
other obstruction.
CAUTION
WARNING
©2023 Johnson Outdoors Marine Electronics, Inc.