MINN KOTA CORDED FOOT PEDAL Manuel Du Propriétaire page 7

Stow/Deploy
The Stow/Deploy button is located at the bottom of the Foot
Pedal. It functions to stow and deploy the motor when the Foot
Pedal is operating in Ulterra Mode. The amber MODE
the Indicator Panel will illuminate when in Ulterra Mode. When the
motor is deployed, press the Stow/Deploy button to stow it. When
the motor is stowed, double-press the Stow/Deploy button to deploy
it. When stowing and deploying the motor, the operational function
of the Foot Pedal or paired remote is automatically disabled. The
Prop is also disabled when the motor is stowing or deploying.
When transporting the motor, it is important to always stow the motor and make sure it is secured in place. A secure stow holds the
motor in place during transportation when it is subject to high levels of shock and vibration. Failure to stow the motor may result in injury
or damage to the unit.
Constant
The Constant button is located on the left side of the Foot
Pedal, below the AutoPilot button. It toggles the motor between
Constant motor operation and Momentary motor operation.
The green CONSTANT
CONSTANT
illuminated when the motor is in Constant motor operation. In Constant motor operation, the Prop will continually run at the speed set by
the Speed Control Knob or remote, regardless of whether force is being applied to the Momentary button or Prop ON/OFF button.
Momentary
In Momentary motor operation, the Prop will only run while downward force is applied to the Momentary button. The Momentary button
is on the Toe End of the Foot Pedal. Applying downward pressure to the Momentary button will turn the Prop "on." The motor will then
run at the speed set by the Speed Control Knob or a paired remote. Removing downward force from the Momentary button will turn the
Prop "off." No indicator light is associated with the Momentary button. The Momentary button functions similarly to the Prop ON/OFF
button but works in both Normal Mode and Ulterra Mode.
If the Prop encounters an obstruction while in Constant or Momentary motor operation, while the Prop is running, the increased
electrical current generated by the obstruction will signal the motor to decrease power to the Prop in order to prevent damage. If the
current overload is detected for more than 20 seconds, the Prop will be disabled to prevent damage to the motor. In this event, the
operator can turn the Prop back on after clearing the obstruction.
©2023 Johnson Outdoors Marine Electronics, Inc.
MODE
WARNING
LED on the Indicator Panel will be
CAUTION
LED on
When stowing or deploying the motor, keep fingers clear of all
hinges, pivot points and all moving parts. When stowing and
deploying the motor, ensure that it doesn't contact the boat,
trailer, or any other obstruction.
NOTICE:
when it encounters an obstruction.
FOOT PEDAL OPERATION
WARNING
The motor will not auto correct to drive straight
minnkota.johnsonoutdoors.com | 7