Publicité
Operating modes
You can use this appliance in the air extraction or the
recirculation mode.
Exhaust air mode
The air that is drawn in is cleaned by
the grease filters and conveyed to the
exterior by a pipe system.
Note: Ventilation may not exit through an already
operational smoke or exhaust chimney, nor a duct
used for ventilating furnace installation areas.
▯
If the ventilation is intended to pass through a
smoke or exhaust chimney that is not in
operation, the responsible area heating
inspector must give approval.
▯
If the ventilation passes through an external wall,
use a telescope wall sleeve.
Recirculation
The aspirated air is cleaned by the
grease filters and an activated charcoal
filter and is returned to the kitchen.
Note: You must install an activated charcoal filter to
bind odors in the recirculation mode. Refer to the
manual or ask your specialist dealer for details of the
various options for operating the appliance in the
recirculation mode. You can obtain the necessary
accessories from specialist dealers, from our after-
sales service or in the online shop.
When used in recirculation mode, to reduce the Risk
of Fire and Shock use only conversion kit Model
AA210110 / AA211812. Please refer to the section
"Accessories" in this manual.
Operating the appliance
Note: Turn the extractor hood on when you start
cooking and switch it off again a few minutes after
you have finished cooking. This is the most effective
way to eliminate cooking vapor.
Operating the appliance
Control panel
Explanation
#
Fan On/off
1
Fan speed 1
2
Fan speed 2
3
Fan speed 3
Ž
Intensive setting
ž
Run-on funcion
œ
Saturation display
c
Light on/off
Turn on the fan
Switching on
Press down lightly in the middle of the handle strip to
extend the filter pull-out.
ÿ
1
Press the
button to switch on the appliance.
The fan starts in setting 2.
2
With the buttons 1, 2, 3 or
according to the cooking situation.
Switching off
ÿ
Use the
button to switch the appliance off.
Ž
, set the fan speed
9
Publicité
