Intense level
For especially strong odor or vapor, use the intense
level.
ÿ
1
Press the
button to switch on the appliance.
The fan starts in setting 2.
Ž
2
Press the
button to switch on the Intensive
setting.
Note: If the button was pressed while the fan is
running on speed 1, 2 or 3, the electronics
automatically switch back to the previously-
selected fan speed after 5 minutes.
3
To switch off the Intensive setting earlier, press
ÿ
the
button or the button for another fan
speed.
Setting the duration
You can set the duration after which the Intensive
setting switches off automatically.
Duration
Press buttons simultaneously
Ž
3 minutes
and 1
Ž
5 minutes
and 2
Ž
10 minutes
and 3
The factory setting is set to 5 minutes.
Run-on function
The run-on function can be set for any fan speed.
1
First press the button for the desired fan speed
Ž
1, 2, 3 or
and then press the
Notes
‒ The run-on time is ten minutes for all fan
speed settings. Once this time has elapsed,
ventilation switches off automatically.
‒ If the lighting is switched on, it remains on.
2
To switch off the run-on function earlier, press
ÿ
the
button.
10
Interval ventilation
For interval ventilation, the device is switched on
automatically for five minutes per hour.
1
2
3
Lighting
The lighting can be switched on and off
independently of the ventilation.
Press the
Setting the brightness
Press and hold the
brightness is reached.
Saturation notification
After 30 hours of operation, the saturation display
of the grease filter blinks.
▯
ž
button.
▯
ÿ
Press the
button to switch on the appliance.
The fan starts at level 2. The interval ventilation
can be used on level 1, 2 or 3.
Press the run-on button
Note: This mode is indicated by alternating
ž
lighting up of the
button with the
corresponding speed.
To end interval ventilation, press the
@
button.
@
button until the desired
At the latest now the metal mesh grease filter
should be cleaned. For instructions on how to
clean the metal mesh grease filter, please see
Cleaning and maintenance
the chapter about
While the saturation display is blinking, it can be
œ
reset with the
button.
ž
twice.
ÿ
button.
œ
.