Publicité
Before you begin
These instructions apply to several appliance
models. It is possible that individual features are
described that do not apply to your appliance.
Tools and parts needed
▯
Measuring tape
▯
Pencil
▯
Torx screwdriver TX20
▯
Drill with the following bits: 5/16" (8 mm)
▯
Spirit-level
▯
Aluminum tape (DO NOT use insulating tape)
▯
Exhaust channel (configuration depends on the
installation situation)
▯
Additional sheet metal screws (if necessary for
installation of the exhaust air duct)
Parts included
Appliance width 24" (60 cm):
18
B e f o r e y o u b e g i n
Appliance width 36" (90 cm):
Safety clearances
9
WARNING
Risk of fire
Grease deposits in the grease filter may catch
fire. The specified safety distances must be
observed in order to prevent an accumulation
of heat. Observe the specifications for your
cooking appliance. If gas and electric
cooktops are operated together, the largest
specified distance applies.
Only one side of the appliance may be
installed directly next to a high-sided unit or a
wall. The distance between the appliance and
wall or high-sided unit must be at least 2"
(50 mm).
The minimum distance between the supporting
surface for the cooking equipment on the hob and
the lowest part of the range hood must be not less
than 17 " (430 mm) from electric cookers and 25
(650 mm) from gas or mixed cookers.
^
"
Publicité
