Panasonic NE-1853 Mode D'emploi page 22

How to Operate NE-2153-2/NE-1653/NE-1853
L. To Read Program List
2. Open the door and leave it open.
The oven lamp will turn on. "0" will appear in the display. While touching Start Pad,
touch Prog Pad until the Digital Display Window show "PROG" and "P" (for more
than 2 seconds).
3. Program Lock feature is now deactivated.
Note: In "Program Unlock"
a. Oven reverts to a two-touch operating mode (Number/Memory Pad + Start Pad).
b. Repeat and interrupt features are operational.
c. Memory Pads can be programmed.
d. Manual heating is operational.
e. Tone loudness control, length control and pitch control (beep tone at the end of
heating cycle/filter cleaning alarm) are operational.
1. Open the door and leave it open.
2. While touching Start Pad, touch Number Pad "1".
All currently programmed information (the program set into each Number/Memory
Pad (A0 to C9), Beep Tone, Program Lock, Oven Lamp settings when the door is
open, Oven Lamp blink settings at the end of heating cycle and Oven Lamp
reduction settings during cooking information) will continuously appear.
Note: When the filter cleaning alarm counter is set, this appears after Program Lock.
How to erase memory content
1. Open the door (keep it open) and touch Prog Pad.
2. Select the memory number you want to erase, and touch Power Level Selector Pad.
3. Touch Stop/Reset Pad, and "0" is displayed to indicate that memory is erased.
*Memory content is automatically erased if overwritten.
- 22 -