Maintenance; Routine Maintenance; Maintenance Of The Rf Contact - Silk-n ToothWave H7001 Mode D'emploi

6. Clean the device with warm water, and store in open air
whilst it is wet.

7. Maintenance

7.1 Routine maintenance

U
After use, wash the brush head under running water to
remove any toothpaste or debris.
[
Do not wash with soap or chemicals.
U
If debris or toothpaste accumulates on the handle (#2),
wash under running water and dry with a clean dry cloth.
[
Do not try to remove any stuck debris from the brush head
(barrier and/or electrodes). In such cases, replace the brush
head (#1). Refer to section 7.4 Replacing the brush head.

7.2 Maintenance of the RF contact

U
Once a month, remove the brush head
(#1) from the handle (#2). Clean the
groove in the handle (#2) to remove
any toothpaste or debris that may have
accumulated. Use a cotton bud, rinse and
dry with a clean dry cloth.
U
Remove debris and excess toothpaste
from the brush head (#1) and handle (#2). Clean the
underside of the brush head (#1) using a cotton bud.
U
If another person is going to use their brush head (#1), be
sure to rinse and wipe down the handle (#2), including the
connection between the brush head (#1) and the handle
(#2) before another person uses the device.
11
EN