Get Started; Cleaning & Maintenance; Cleaning The Toothbrush - Silk-n ToothWave H7001 Mode D'emploi

6. Get started!

1. Rinse the bristles under lukewarm water.
2. For best results, apply a generous amount of toothpaste.
You can use any commercial toothpaste.
3. Turn on the device. Short press the control button
many times as needed to select your treatment mode.
4. Move the brush in circular movements, slowly and
systematically from tooth to tooth, and gently massage the
gums. Make sure the bristles are always in good contact
with your teeth. Silk'n ToothWave comes with soft bristles
to protect your teeth and gums. Brush gently, and apply
only light pressure when brushing. Do not scrub.
5. Brush for 2 minutes. You will feel a slight vibration every
30 seconds (1 vibration at 30 seconds, 2 vibrations at 60
seconds and so on). After the vibration(s), you can move
to another section of the mouth (refer to section 4.
Treatment plan). After 2 minutes, the device will shut down
automatically.
6. Clean the device and store in open air whilst it is wet.
7. Cleaning & maintenance

7.1 Cleaning the toothbrush

It is important to clean the device after each use. Use
lukewarm water.
U
Clean the brush head (#1) and handle (#2), especially if your
toothpaste contains baking soda, or other bicarbonates.
This is to prevent the plastic from cracking.
11
EN
(#3) as