Fcc Declaration Of Conformity - Silk-n ToothWave H7001 Mode D'emploi

18. FCC Declaration of Conformity

EN
November 26, 2020
Declaration of Conformity 47 CFR § 2.1077 Compliance Information
Model:
Responsible Party U.S. Contact Information:
Email:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Changes or modifications not expressly approved by Home Skinovations Ltd. could void the
user's authority to operate the ToothWave device.
Signature:
Name: Ben Zion Levi
ToothWave H7001
Yair Malca
Inmode U.S. office
17 Hughes Irvine, CA 92618
USA
yair.malca@inmodemd.com
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Date: November 26, 2020
Title: co-CEO
22
Home Skinovations Ltd.
Tavor building,
Shaar Yokneam, POB 533
Yokneam 2069206, Israel
www.silkn.com